|
Home
For Users
For Developers
Contact Us
|
Installation
WARNING: FRAT is currently a work in progress and is under no mandate to maintain backward compatibility.
Dependencies
- FRAT is configured and built using CMake. A basic understanding of CMake is assumed. Documentation and tutorials can be found at [1]. In this walkthrough, we demonstrate configuration at the linux command line. The CMake GUI can also be used in Windows or Linux.
- FRAT requires a full setup of the Insight Toolkit (ITK), GenerateCLP, and a working FFTW setup. The easiest way to get ITK and GenerateCLP is to do a complete install of TubeTK. For build instructions, go here. For FFTW installation instructions, go here.
Download FRAT Source Code
NOTE: Currently FRAT is available only as source. Binary executables may be available in the future.
- Create the directory for your FRAT setup. We'll refer to it as FRAT_DIR for the sake of clarity.
- In FRAT_DIR, clone the repository
cd FRAT_DIR
git clone git://gitorious.org/frat/frat.git
- After cloning you should now have a FRAT_DIR/frat/ directory
Configure build
- First, create a build directory and enter it. Typically this will live alongside the source directory.
mkdir build
cd build
- Now, use cmake to configure the build
ccmake FRAT_DIR/frat
- You will now be presented with the cmake configuration interface. Press 'c' to run the initial configuration.
- You will initially be presented with errors since the paths to ITK and GenerateCLP probably won't be immediately found.
- If you built ITK and GenerateCLP by building TubeTK (assuming TubeTK built with SuperBuild in TubeTK_BUILD_DIR), set the paths as:
ITK_DIR TubeTK_BUILD_DIR/GenerateCLP-Build
GenerateCLP_DIR TubeTK_BUILD_DIR/Insight-Build
|
