[ITK] [ITK-dev] Adding FDFImageIO

Williams, Norman K norman-k-williams at uiowa.edu
Fri May 16 10:54:12 EDT 2014


Right now I have a review patch up that adds FDFImageIO: http://review.source.kitware.com/#/c/15457/

Here’s the question:  I’ve done it as a remote module (which is what Hans asked me to do).  Since doing that,  I contacted the original author, and he gave me permission to replace his original header comments which mention GPL2. So it could be under the ITK license, and go into ITK/Modules/IO.

It’s very small and requires no new support library.   Should I make it part of ITK or leave it a remote module?



________________________________
Notice: This UI Health Care e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and may be legally privileged.  If you are not the intended recipient, you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited.  Please reply to the sender that you have received the message in error, then delete it.  Thank you.
________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/community/attachments/20140516/f7c1a1d5/attachment.html>
-------------- next part --------------
_______________________________________________
Powered by www.kitware.com

Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html

Kitware offers ITK Training Courses, for more information visit:
http://kitware.com/products/protraining.php

Please keep messages on-topic and check the ITK FAQ at:
http://www.itk.org/Wiki/ITK_FAQ

Follow this link to subscribe/unsubscribe:
http://www.itk.org/mailman/listinfo/insight-developers


More information about the Community mailing list