[ITK-dev] [ITK] Adding FDFImageIO

[Matt McCormick]

Hi Kent,

Thanks for working on this.

It would be good to have it as a Remote Module for at least one
release cycle for hardening.

Thanks,
Matt

On Fri, May 16, 2014 at 10:54 AM, Williams, Norman K
<norman-k-williams at uiowa.edu> wrote:
> Right now I have a review patch up that adds FDFImageIO:
> http://review.source.kitware.com/#/c/15457/
>
> Here’s the question:  I’ve done it as a remote module (which is what Hans
> asked me to do).  Since doing that,  I contacted the original author, and he
> gave me permission to replace his original header comments which mention
> GPL2. So it could be under the ITK license, and go into ITK/Modules/IO.
>
> It’s very small and requires no new support library.   Should I make it part
> of ITK or leave it a remote module?
>
>
>
> ________________________________
> Notice: This UI Health Care e-mail (including attachments) is covered by the
> Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential
> and may be legally privileged.  If you are not the intended recipient, you
> are hereby notified that any retention, dissemination, distribution, or
> copying of this communication is strictly prohibited.  Please reply to the
> sender that you have received the message in error, then delete it.  Thank
> you.
> ________________________________
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Kitware offers ITK Training Courses, for more information visit:
> http://kitware.com/products/protraining.php
>
> Please keep messages on-topic and check the ITK FAQ at:
> http://www.itk.org/Wiki/ITK_FAQ
>
> Follow this link to subscribe/unsubscribe:
> http://www.itk.org/mailman/listinfo/insight-developers
>
> _______________________________________________
> Community mailing list
> Community at itk.org
> http://public.kitware.com/cgi-bin/mailman/listinfo/community
>