[Insight-users] dynamic clipping

[Luis Ibanez]

Hi Luca,

Are your planes parallel to the Axial, Sagittal and Coronal directions ?

If that is the case,
then you can "clip" the image by using the RegionOfInterest filter.

http://www.itk.org/Insight/Doxygen/html/classitk_1_1RegionOfInterestImageFilter.html


     Regards,


         Luis


--------------------
Luca Ramundo wrote:
> Hi everybody,
> I'm developing an application that loads DICOM on four quadrants and 
> then loads 3d volume overlapping that in  a right position.
> Now I'd like to see only a part of my models make a dynamic clipping 
> depending on the axial,sagittal, orthogonal position of the plans.
> Is possible? Someone has done something like this?

> _____________________________________
> Powered by www.kitware.com
> 
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
> 
> Please keep messages on-topic and check the ITK FAQ at: http://www.itk.org/Wiki/ITK_FAQ
> 
> Follow this link to subscribe/unsubscribe:
> http://www.itk.org/mailman/listinfo/insight-users