[Insight-users] How to set the angle of a CylinderSpatialObject ?

[Dan Mueller]

Hi Juliette,

To the best of my knowledge, itk::CylinderSpatialObject only allows a
full cylinder. To achieve what you desire, you will have to use a mesh
(if you need to use spatial objects then itk::MeshSpatialObject).

Hope this helps.

Regards, Dan

2009/9/11 Juliette Deniau <juliette.deniau at yahoo.fr>
>
> Hi,
>
> I would like to insert in my volume a cylinder object using itk::CylinderSpatialObject but the cylinder I obtain is only a quarter of the cylinder I want: form 0 to 45 degree (see attached picture). Is there any fonction realted to CylinderSpatialObject to specify the angle (from 0 to 360 degree)? Or how I can get a full cylinder  ?
>
> Thnaks
>
> Juliette