[Insight-users] Fwd: Installing ITK

[John Drescher]

---------- Forwarded message ----------
From: Kishore Devisetti <kishoredvrs at gmail.com>
Date: Fri, Dec 10, 2010 at 3:42 PM
Subject: Re: [Insight-users] Installing ITK
To: John Drescher <drescherjm at gmail.com>


John,
Thanks for your prompt response. I still have problems getting started.
I found a files named "ITK.sln" in C:/InsightToolkit-3.20.0/Bin and I
double clicked it. A lot of functions were loaded in Visual Studio.
The instruction in ITK software, 2nd edition say following, but I am
not sure how to do
To create a new project with ITK is to create a new directory somewhere in
your disk and create two files in it. The first one is a
CMakeLists.txt file that will be used by
CMake to generate a Makefile (if you are using UNIX) or a Visual
Studio workspace (if you are using MS-Windows). What should be the
content of the .txt file?
The second file is an actual C++ program that will exercise some of
the large number of classes available in ITK. What is the content of
this C++ file ?

Should I run CMakeSetup after above steps and provide my newly created
directory as source dir and binary dir for new project?
Is this a one time configuration process.
Thanks
Kishore
On Fri, Dec 10, 2010 at 1:19 PM, John Drescher <drescherjm at gmail.com> wrote:
>
> > I am trying to install ITK and I am finding trouble performing the following
> > step
> >
> >
> >
> > “ load the workspace named ITK.dsw (if using MSDEV) or ITK.sln (if using the
> > .NET compiler) from the binary directory you specified in the CMake GUI.”
> >
> >
> >
> > This is after I configured source code and binary locations in CMake and
> > then clicked Generate (Visual Studio 10)
> >
> > I am unable to know where I should load the workspace.
> >
> >
> >
> > The binary directory I specified in my CMake GUI was
> > “C:/InsightToolkit-3.20.0/Bin”.
> >
> > When I went to this directory I did not find any ITK.dsw.
> >
> There should not be a .dsw for  Visual Studio 2010. It should be a .sln
>
> Did you run generate after you ran configure in cmake-gui?
>
> John



--
Thanks,

Kishore Devisetti
Image Analysis Engineer
Hamilton Eye Institute, University of Tennessee
Office # 901-448-7830
Cell   # 901-268-7533



-- 
John M. Drescher