No subject

"When this filter is updated, NumberOfLevels outputs are produced. The
N'th output correspond to the N'th level of the pyramid."

So if the filter has 3 levels then the output images are obtained via:

  ZerothLevelOutput  =3D filter->GetOutput(0);
  FirstLevelOutput   =3D filter->GetOutput(1);
  SecondLevelOutput  =3D filter->GetOutput(2);


Is this the info you are looking for?=20

- Lydia


> -----Original Message-----
> From: Peter Lorenzen [mailto:lorenzen at cs.unc.edu]
> Sent: Friday, May 23, 2003 2:41 PM
> To: Insight-users at public.kitware.com
> Subject: [Insight-users] RecursiveMultiResolutionPyramidImageFilter
>=20
> Hi All,
>=20
> Does anyone know how to use the GenerateOutputRequestedRegion or other
> method to extract computed reduced resolution datasets from an
> itkRecursiveMultiResolutionPyramidImageFilter? There is plenty of
> documentation on how to set the shrink schedule and how to connect
this
> filter to other filters but not much, that I have found, in the way of
> directly accessing the output of this filter.
>=20
> Thanks in advance,
>=20
> - Peter
>=20
> --
> Peter J. Lorenzen
> Ph.D. Student
> Department of Computer Science
> University of North Carolina at Chapel Hill
> Sitterson Hall 268, Campus Box 3175
> Chapel Hill, NC  27599-3175
>=20
> TEL (919) 962-1879
> FAX (919) 962-1699
> E-MAIL lorenzen at cs.unc.edu
> WEB PAGE http://www.cs.unc.edu/~lorenzen
>=20
> _______________________________________________
> Insight-users mailing list
> Insight-users at public.kitware.com
> http://public.kitware.com/mailman/listinfo/insight-users