[vtkusers] VTK and CAD

[anast.jm at pg.com]

Hi....you can always write your data out in STL format using vtkSTLWriter. Most
CAD packages can handle this format. It is triangles only so you may need to run
your data through vtkTriangleFilter first......hope this helps, john


                                                                
 Internet Mail Message                                          
 Received from host:      public.kitware.com                    
 [24.97.130.19]                                                 
                                                                


From: "Ng Hong Wan" <hongwan at myrealbox.com>@public.kitware.com on 07/18/2002
11:26 AM ZE8
                                                                                                 
      "Ng Hong Wan" <hongwan at myrealbox.com>           To:   <vtkusers at public.kitware.com>        
                        @public.kitware.com           Cc:    (bcc: John Anast-JM/PGI)            
                                              Subject:      [vtkusers] VTK and CAD               
                                                                                                 
                                   Sent by:                                                      
          vtkusers-admin at public.kitware.com                                                      
                        07/17/2002 11:26 PM                                                      
                                                                                                 
                                                                                                 






Hi,

I had seen somesimilar questions posted earlier,but no answers till date.

isit possible to getdata processed byVTKand exportit to CAD modelers, something
like whatmaterializemimic can do.