[Insight-users] Deformable mesh

[Leila Baghdadi]

Sami,

You must make sure that you have VTK, fltk and itk properly built on
your system.

Having said that changes to any of the above might create a problem for
the application, 

I will try to do some testing soon,

will e-mail the list

Leila 

On Wed, 2006-17-05 at 05:55 +0000, sami bourouis wrote:
> Hi all,
> First, excuse me, if my English is not well. Thankyou.
> I have here a question about the example “deformable model simplex mesh”. In 
> reality, I have a project to do about deforming surfaces (mesh) into 
> 3D-image like which doing by J. Montagnat and Hervé Delinguette. I’m asking 
> firstly if this example do the same thing with my purpose or no.  Because 
> this can help me to continuous or not used your program.
> My objective is the introduction of a model (triangular or simplex mesh) in 
> a 3D image ( *.mhd or other) and computing some internal and external forces 
> to deform this model and finally visualize the deformation. I’m tested your 
> program:
> -1. I’m load “example.mhd”
> -2. I’m clicked on the button “creat mesh”, and I can visualize the sphere.
> Just now, evry thing is well ().
> But the problem is that, after few minute, I can’t visualize the deformation 
> of the model after cliked on the button “deform meh”. So my question is what 
> is the problem here?
> Thank you very very much and excuse me again for this very long message.
> Sami,
> 
> _________________________________________________________________
> MSN Messenger : discutez en direct avec vos amis ! 
> http://www.msn.fr/msger/default.asp
> 
> _______________________________________________
> Insight-users mailing list
> Insight-users at itk.org
> http://www.itk.org/mailman/listinfo/insight-users